Yuku free message boards

Sorry for the late reply. I haven't been at the FIB much in the last week or two.
The Big Muff from BYOC took me a day or two to solder and wire up. Basically, any of those pedals usually take me parts of two evenings. I'll solder up the entire board in a couple hours on the first night. Then, I'll take another hour or two to wire up the rest of the stuff (3PDT switch) input and output jacks, AC input jack, pots, etc. to the board. I could do it all in one day, but I want to take my time and not get too burned out and make mistakes.

I check each and every single resistor vs. its color code and then with my multimeter before soldering them in. I just don't trust my eyes to read those tiny stripes! I have a hard time reading the insanely small (and low contrast!) markings on some of the caps, so I check those too. Everything gets bent with tiny, needle-nose pliers before soldering and then snipped in back right away.

So far, this approach has worked pretty well. In building five pedals, I've only made two real mistakes. I wired a transistor wrong (reversed two outside leads) in a fuzz, but that was really easy to fix. It was obvious because the gain was insanely low and it was real clear I goofed something up. At least it was only one of the three transistors! With some common sense and some feedback from the BYOC discussion board, it was an easy fix.

The second mistake was my last pedal. My five year old daughter really, really wants to help. She was my official resistor tester! She holds the meter's test leads against the resistor while I read the display. I got distracted and confused a 68K resistor for a 6.8K (or maybe vice versa, can't remember now). It was easy to figure this one out when I got to the last resistor and I had a 6.8K left instead of a 68K (or the opposite...). Pain in the butt to fix, but not that bad. After about a five minute de-solder and solder operation, all was well.

So far, I've completed five pedals, and all (except the fuzz with the backwards transistor) have worked properly the first time I tested them.

One disclaimer: I've only described how long it takes to solder and wire everything up - basically a few hours. I haven't talked about prettying up the cases. I figured that I may as well have them look nice too, so I've spent some effort on the pedal's exterior. I sand, prime, paint, decal, then clearcoat each one. That actually takes WAY LONGER than the actual electrical stuff. Still, it's only a few days. It's kind of fun designing little decals and such. Maybe I'll throw some decals onto the partsocasters I've built some day!